IKEA FHIN4T Instrukcja Użytkownika Pobierz pdf (Strona 10)

Problem Possible cause Remedy

The child safety device is

switched on

.

Deactivate child safety device

(See the section “Child safety

device” ).

Several sensor fields were

touched at the same time.

Only touch one sensor field.

Acoustic signal sounds, appli-

ance switches off.

One or more sensor fields

have been covered for longer

than 10 seconds.

Uncover sensor field.

Display is switching between

two heat settings.

Power management is reduc-

ing the power of this cooking

zone.

See the section "Switching the

power function on and off".

lights up on the heat setting

display.

Unsuitable cookware. Use suitable cookware.

No cookware on the cooking

zone.

Place cookware on the cook-

ing zone.

The diameter of the bottom of

the cookware is too small for

the cooking zone.

Move onto a smaller cooking

zone.

symbol plus a number ap-

pears on the heat setting dis-

play.

Electronics fault. Disconnect the appliance from

the electrical supply for a few

minutes (Take the fuse out of

the house’s electric system) If

after switching on again,

is

displayed again, call the after

sales service.

lights up on the heat set-

ting display.

Overheating protection for

the cooking zone operates.

Switch off the appliance. Re-

move the hot cookware. After

approximately 30 seconds

switch on the cooking zone

again.

should disappear,

residual heat indicator can

stay. Cool down the cookware

and check it with the section

Cookware for the induction

cooking zone.

If there is a fault, first try to find a solution to

the problem yourself. If you cannot find a sol-

ution to the problem yourself, contact your

dealer or the After Sales Service.

If you operated the appliance wrongly, or

the installation was not carried out by a

registered engineer, the visit from the customer

service technician or dealer may not take

place free of charge, even during the warranty

period.

ENGLISH 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 55 56

Komentarze do niniejszej Instrukcji

Brak uwag